| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-17-2010, 10:22 AM
| |||
| |||
I have recently been using area selection to clean up imported cloud points, however I have only needed to do this from top gview until now. When I create my bounding geometry from the right or even if I create a new work plane the area selection does not work. So could there be something I am doing wrong or can this only be used from the the top?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- CNC Selection | racingtreeman | WoodWorking | 0 | 04-14-2009 07:37 PM |
| Cut area selection(UG type) for machining components. | thirumalkumarn | EdgeCam | 2 | 07-22-2007 02:34 PM |
| how to mill inside an area and not over an area? | jedioliver | Visual Mill | 10 | 02-21-2007 11:52 PM |
| Bit selection | HB Adams | WoodWorking | 1 | 06-19-2006 05:32 PM |
| Looking for Mentor in Bay Area, CA area | Allistah | Mentors & Apprentice Locator | 3 | 11-08-2005 02:05 PM |
| | |
Linear Mode
