Problem Mastercam X3 and Printer Do Not Get Along - CNCzone.com-The Largest Machinist Community on the net!

zephyrmachine · #1 05-12-2010, 07:10 PM

I have Mastercam X3 on my desktop, and after I installed Service Pack 3 for Windows XP, I would start the program, and it would start and close immediately. If I close the process "spoolsv.exe" (Print Spooler Service), it runs fine, but I can't print drawings. Any input can be greatly appeciated.Thanks in advance.

Superman · #2 05-13-2010, 06:10 AM

I've had Win SP3 stuff up ( what I think ) data paths or registry settings

Try in this order
-you may get away with re-running the last MU update
-try a repair of the X3
- reinstall X3

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Converting a laser printer into a 3d laser printer	João Carimo	General Metal Working Machines	22	03-08-2012 10:21 AM
Should I go for Laser Printer?	ethervaughn	Printing, Scanners, Vinyl cutting and Plotters	4	07-21-2009 04:25 AM
printer parts	recoton	General Electronics Discussion	5	07-31-2007 07:53 PM
Printer for PCB ?	WayneHill	General Electronics Discussion	18	10-05-2005 12:42 AM
slides from printer?	JFettig	DIY-CNC Router Table Machines	7	04-24-2004 05:13 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)