Rapid Advance For Drill Mastercam 9.1

[Tony Salerno]

Is ther a way to rapid to a negative number when drilling, my peck was set up as a chip break, changed it to a peck, cannot program firts peck it is shaded out. This is for Mill

[Mike Mattera]

First Peck, Subsequent Peck, Dwell.... these are all controlled bu the >.txt file that goes with your .pst file (your port). You you have the .txt file in your posts folder. Most peopl dont copy them when they move or share a post. Or they rename then post and dont rename the .txt file. If you post is based on the standard MPFan.pst. you can copy that MPFan.txt you the same name as your post.txt
(MPFan.txt copied to MyPost.txt where MyPost is the name of your postprocessor)

Mike Mattera