| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-01-2010, 11:18 AM
| |||
| |||
Can someone explain to me why CNC Software had to mess with the drill sorting? In previous versions, I could select drilling locations and that would be the order in which Mastercam would accept them but now it is never is the way I selected them. Am I doing something wrong?  |
|
#2
04-01-2010, 12:47 PM
| ||||
| ||||
__________________ If you can ENVISION it I can make it |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| need drill cycle to post every point location. | kesparate | Post Processors for MC | 1 | 03-11-2009 10:40 AM |
| drill sorting | camtd | GibbsCAM | 7 | 01-07-2009 08:41 AM |
| Sorting out the steps | Shanghyd | Stepper Motors and Drives | 7 | 10-25-2006 06:00 AM |
| need help sorting out these motors | russell | DIY-CNC Router Table Machines | 1 | 03-19-2006 12:14 PM |
| help sorting wires to two secondaries | snaggletto | General Electronics Discussion | 3 | 07-02-2004 04:01 PM |
| | |
Linear Mode
