| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-09-2010, 10:34 AM
| |||
| |||
Is there a way to have mastercam setion a toolpath into panels? I have a design that is too long to cut on my machine at one time so it would be good if i could layout the cuts and then divide it into two sections. I have seen in ArtCAM a wizard for this but I have not found a place in MasterCAM to do break up the toolpaths. Thanks, Tim  |
|
#2
03-09-2010, 04:18 PM
| ||||
| ||||
| 2 ways that I have done this are: 1. Use "Toolpath, Trim" 2. Restrict the toolpath with a containment boundary |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UK section please..... | glenfraser | Suggestions for the CNCzone.com site. | 0 | 03-02-2007 03:40 PM |
| How about a how to section | DieGuy | Suggestions for the CNCzone.com site. | 1 | 07-15-2005 10:50 PM |
| Welcome to this new section | CNCadmin | General CAM Discussion | 0 | 09-15-2004 12:08 AM |
| Welcome to the CNC section for | CNCadmin | Musical Instrument Design & Construction | 0 | 07-08-2003 10:37 AM |
| | |
Linear Mode
