| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-24-2005, 07:31 AM
| ||||
| ||||
Hi you guys Does anyone have a way to optimise Win XP for mastercam. I am running on a P4 2.4 with 512M ram. Everything works fine except for engrave. As soon as I do a toolpathe with engrave Win XP gives a error message and closes Mastercam. Anyone knows what to do about it. Im stuck Thanks Deon Gerber  |
|
#3
04-26-2005, 09:55 PM
| ||||
| ||||
| What's the error message?
__________________ Matt San Diego, Ca ___ o o o_ [l_,[_____], l---L - □lllllll□- ( )_) ( )_)--)_) (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mach 2 & Win 2000 | qsacracer | Mach Software (ArtSoft software) | 5 | 12-10-2004 01:00 PM |
| Mastercam 8 slows down my computer | Christian | Mastercam | 6 | 05-12-2004 06:58 PM |
| Who is going to win | CNCadmin | CNCzone Club House | 1 | 04-15-2004 01:43 PM |
| Win stepper motor | CNCadmin | General Electronics Discussion | 0 | 02-25-2004 10:05 PM |
| New Contest WIN SERVO MOTORS!!! | CNCadmin | CNCzone Club House | 83 | 07-18-2003 02:16 AM |
| | |
Linear Mode
