Results 1 to 2 of 2

Thread: Hydraulic pump units... two...for free

  1. #1
    Registered
    Join Date
    Feb 2008
    Location
    USA
    Posts
    509
    Downloads
    0
    Uploads
    0

    Exclamation Hydraulic pump units... two...for free

    The company I work for has two larger Hydraulic pump units with tanks in storage. One has a cooling system both are 460 volt 3 ph. As I recall they are probably in the 15 to 25 hp range and around 3000psi. I’d have to check. I’ve been asked to get rid of them as they have sat in storage for around ten or twelve years. The best I call recall is that they both work great, but don’t hold me to it. Anyway, they were left over from testing some Navy ship board Radar tracking units we design for them and I can give them to you for FREE! You just have to come and get them, load them, and provide all shipping and handling and say you will properly dispose of any fluids you throw out. The best I can do is a pallet jack and push a little… PM me if you want them. The company is located in Calif. A town called Healdsburg 95448. I can also give you a tour of the plant if you want…some real neat defense contractor stuff ( you got to be a US citizen).
    Steve


  2. #2
    Registered
    Join Date
    Feb 2008
    Location
    USA
    Posts
    509
    Downloads
    0
    Uploads
    0

    Unhappy Ahhh...your to late...

    ...one of your fellow Users got them.
    Steve


Similar Threads

  1. sh50 hydraulic pump
    By chenzen666 in forum Mori Mills
    Replies: 5
    Last Post: 03-02-2010, 02:20 PM
  2. Need Help!- 3T-D won't energize hydraulic pump relay
    By Jim Shaper in forum Fanuc
    Replies: 11
    Last Post: 05-20-2009, 05:12 PM
  3. Hydraulic motor and pump?
    By DennisCNC in forum Mechanical Calculations/Engineering Design
    Replies: 1
    Last Post: 02-23-2008, 02:53 PM
  4. Setups Units
    By boyvox in forum Mach Software (ArtSoft software)
    Replies: 2
    Last Post: 10-17-2006, 10:47 AM
  5. Hydraulic pump and motor?
    By DennisCNC in forum Mechanical Calculations/Engineering Design
    Replies: 16
    Last Post: 07-28-2006, 01:30 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.