I think s3d may allow you to change the hotbed temps throughout the print but I am unsure as I have never used it.
Hi,
I've got a FlashForge Creator Pro. The Replicator software does not do what I want.
Does Makerbot or any other software allow control over the printer As It Prints? That would be good. I also want a easier way to control the build temp. As such I was told to go into the Gcode and modify it there. I would think there is a way to send that info thru the USB connection....As it prints If possible.
All help is appreciated.....
Is this the champagne bottle breaking on the bow of this sub forum?
Nelson
Similar Threads:
i build the braces that keep american teeth straight......tick tick tick
I think s3d may allow you to change the hotbed temps throughout the print but I am unsure as I have never used it.
Also keep in mind that the bed level will change as the temp changes.