Good Morning do-it yourselfers,
I am seeking a good book or thread on setting up a 2 axis laser cutting and engraving machine…
I recently purchased an XYZ-TECH laser with very nice Panasonic motion controls BUT as it seem… XYZ-TECH lacks the depth of properly setting up the motion control architecture, so I am now stuck with a white elephant.
The X & Y axis does not seem to know when it needs to stop (table size/reference point) and in doing so it crashes into the frame. Not exactly a good situation…!
Currently I have been sorting through the Panasonic Interface control documentation; upon verification of the wiring and system components or lack of…I will have to figure out the root cause of the issue.
My first thought concerning the matter is the encoder settings are all jacked up?
Any constructive advice is most welcome
Thanks in advance,