Yes. Post a sample of the code you want, including the header (beginning), footer (ending) and tool changes.
Dan
Is there another person, besides Joakim, who can write a post?
Similar Threads:
Yes. Post a sample of the code you want, including the header (beginning), footer (ending) and tool changes.
Dan
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
You sure have a lot of comment lines in there. Are they all necessary?
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
You are correct Dan, way crazy unnecessary comments
Been doing this too long
Writing a post everyone - with the understanding of their machine's language and how the code transpiles - can do. It might take time but possible.
Writing the post processor, for example for a 5 axis machine with an unusual setup, I've heard it's possible but so far I've only seen JOM compiled DLLs for that.
This is the way Joakim wrote it. I don't think it's necessary.
Joakim has solved my problem.
Thanks to everyone who took a look at it.