Hi Bruce,
I can do this for you right now. Just one question: What does your G94 line need to look like? Is it simply G94 you are looking for in the safety line? Like this: G40 G54 G80 G90 G94?
Also, I see you enabled fixture offsets, but you don't have it set in the post. I'll fix that too.
Be aware that there is more control available than you currently are seeing in that post you attached. For example, you can control the first move (not to be confused with First Cut). Here is what mine looks like for our Doosan:
*FIRST_MOVE*
N"lnbr" G00G90"fixture_offset""x""y"S"speed"M3
N"lnbr" G43H"toolnr"D"toolnr""z""coolant_on"
N"lnbr" M24
N"lnbr" G05.1Q1R10
N"lnbr" G00"cutter_comp""x""y"
N"lnbr" G00"z"
*END_SECTION*
Here is another section you could add for when the next path doesn't need a tool change. In the following example I just add a note in the post so the operator knows where the paths start and end (since there is no toolchange to indicate this):
*TOOLPATH_CHANGE*
N"lnbr" ( TOOL "toolnr" CONTINUES)
*END_SECTION*
Anyway, let me know about that G94 and I'll repost the altered post.
Thanks,
Dan