You should be able to rotate, pan and zoom just like a regular Rhino viewport.
Dan,
I have successfully run different tool and used cutting planes/regions for different tools. Appreciate your help getting over those learning humps and up the learning curve.
I have searched for this in the docs, but haven't found an answer to a question about the Cut Simulator.
Is there a way to change the point of view of the Cut Simulator beyond just that of a standard isometric view so you can see cuts done on the reverse of the model?
Thank You!
Bruce
Similar Threads:
- Newbie- Moduleworks Simulator question
- Build Thread- simulator
- Any simulator available?
- As A CNC Simulator ONLY
- CNC Simulator
You should be able to rotate, pan and zoom just like a regular Rhino viewport.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I should have found that. I missed the little down tic to open the drop down:
Appreciate that. Perfect! Does exactly what is needed!!!
Bruce