Your question is confusing. You stated which post processor you plan to use, then asked which post processor to use. Or are you asking about the file extension?
Please clarify.
Thanks,
Dan
Hello all,
I'm working on a CNC project that will require me to use as postprocessor called WinCNC_mm with file formats .nc or .tap .
What postprocessor can I use for this machine?
Thank you.
Similar Threads:
Your question is confusing. You stated which post processor you plan to use, then asked which post processor to use. Or are you asking about the file extension?
Please clarify.
Thanks,
Dan
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
This is my first CNC project so I apologize for the mess my question must have been. I did not find that post processor in the list of available ones in madCAM so I was wondering if I could use another in its place. I don't know the type of the machine I'll be working on just yet and that's the information I got from the workshop.
Thank you for your reply, Dan!
If you can request a short sample of code that shows the beginning, end and tool changes, I can make sure you have a good post.
Dan
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thank you, Dan, I'll post a file as soon as I have it.
Hello again,
Here is a sample code file.
https://www.dropbox.com/s/j4amar8xjt...emplu.tap?dl=0
Thank you,
Alex
Can you paste it here? Dropbox wants to access my contacts list, and I'm not good with that.
Thanks,
Dan
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
T1M6
G17
G0Z70.000
G0X0.000Y0.000S15000M3
G0X799.552Y282.406Z10.000
G1Z-5.000F3000.0
G1X798.194Y280.555F4560.0
X413.336Y47.351
G2X409.215Y48.362I-1.555J2.566
G1X375.143Y106.334
X342.432Y165.590
X311.148Y226.085
X281.352Y287.770
---
X308.159Y2458.912
G2X312.181Y2460.264I2.687J-1.334
G1X715.207Y2260.090
G2X716.559Y2256.068I-1.334J-2.687
G1X690.655Y2201.937
X666.182Y2146.675
---
X1163.506Y627.669
X1185.779Y569.351
X1185.749Y567.055
G0Z10.000
G0X0.000Y0.000Z70.000
G0Z70.000
G0X0.000Y0.000
M30
The machine doesn't do automated tool changes.
Thank you,
Alex
I'll take a look when I get a chance, thanks.
Dan
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)