Problem New Profile features a little buggy


Results 1 to 2 of 2

Thread: New Profile features a little buggy

  1. #1

    Default New Profile features a little buggy

    Hi there,

    The new lead option (as well as others) in the profile command are fantastic, but I have a part in which MadCAM is attempting to start the lead at the lowest point, then go up, and then back down. I can work around this but simply specifying an entry angle, but wanted to document this problem. It does not seem to do this on closed curves and worked out brilliantly on some test cuts I made with it yesterday.
    New Profile features a little buggy-profileglitch-jpg
    Many thanks,
    O

    Similar Threads:


  2. #2
    Member Dan B's Avatar
    Join Date
    Apr 2003
    Location
    Ontario
    Posts
    1354
    Downloads
    0
    Uploads
    0

    Default Re: New Profile features a little buggy

    Blame Microsoft. If they hadn't forced Joakim's hand to distribute the pre-release, all these little buglets would have been fixed.

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

New Profile features a little buggy

New Profile features a little buggy