...and the problem is?..
I try to do some cut >> 2015-01-14_1634 - OlaviJing's library
Same method is ok but starting place >>2015-01-14_1641 - OlaviJing's library
Similar Threads:
- Problem- SteelTailor provide cutting parameter table for flame cutting operation?
- Problem- Problems of setting plasma cutting mode of SteelTailor SmartIII CNC cutting machine
- New Product- Cutting Quality Makes TubeTailor I Tube Cutting Machine Stand Out
- LIMAC fiber laser cutting machine for stainless steel cutting video
...and the problem is?..
Yes, should be able to understand what I wanted, but it does not matter anymore when I got it done, that is, this is what I wanted>>2015-01-14_1850 - OlaviJing's library
I am sorry for the English language skills are poor, and I use a translator, so I understand that often I can not tell you what I'm trying to do.
I am very pleased with MAdCAM in the program, and the advice that I have received.
I have built a 5-axis machine itself, and I'm learning to use MAdCAM, I have already done during the week saanu toolpaths.
Kai
More question: If you do this way whether straight cylinder bore.
I use the same blade as the video
Could this question to get an answer.
Will there be a hole in the straight, or a cone, with this method?
It's hard to tell from the video, but I would think the hole would be straight if the angle of the tool approach is greater than the taper.
Would it gouge if it was less? I don't know for sure, as I've never had a scenario like this. If I was doing this I would use a traditional ball nose cutter and do an indexed path. But I'm not in the jewellry world so maybe there is a reason for this type of path.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks for the advice I ask more about that later.
Now there is another serious problem.
Milling of this ring, and this is a simulation>>>2015-01-17_1649 - OlaviJing's library
It looks pretty good, but the result is that which is reflected in the image.
Z-value is too low,, let me know what is wrong,, when it makes that the toolpath?
Z-value is not allowed to go below 10mm