- How to restrict cutter travel in 4 axis machining
-
Member
How to restrict cutter travel in 4 axis machining
When doing 4 axis machining, I'd like to limit how close the cutter can move to the chuck holding the part. I tried using region curves, but that didn't work well. What I really want is a clipping plane defined by its x value. Is there a way to do this? If it matters, I am doing a roughing pass.
Mitch
Similar Threads:
-
-
Member
-
Member
Re: How to restrict cutter travel in 4 axis machining
I am using a custom stock model. Even though it ends at the same planes as a cylinder surface would, there are tool paths generated that are past the ends.
-
Member
Re: How to restrict cutter travel in 4 axis machining
Any idea why, when I use the stock model, toolpaths are generated which are outside the stock?
-
Member
- How to restrict cutter travel in 4 axis machining
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules