Call your IT department.
The MadCam website is blocked by Lockheed Martin Corportate network, returning the following message:
"Web Site Content Unknown
The Web site requested has not been evaluated and categorized. Since the content of this Web site is unknown, it poses a potential security risk, both to Lockheed Martin and to you personally.
Unknown URL: madCAM CAM plug-in for Rhino3D
Category: none"
I think the issue is the "Category: none". Note that Mastercam, CamBam, Vectric, etc. sites are all available.
Similar Threads:
Call your IT department.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Gerry, Thanks for the insightful suggestion. However, I do not mention this issue for my own benefit, as I can acces the site perfectly at home. I note this issue as a tip to Joakim/MadCam so that he may choose as he wishes to correct a small web design oversite that is preventing his site from being viewed by 70,000 Lockheed Martin employees.
Just out of curiosity, is madCAM being used by Lockheed Martin? I always imagined a company of that size would be using Catia, NX etc. not Rhino with a CAM plug-in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
If you only knew how large companies there are using Rhino...