Upgrading from entry to 4th axis - CNCzone.com-The Largest Machinist Community on the net!

eurolenny · #1 01-12-2012, 01:17 PM

How do I install the new key to upgrade from entry to 4th axis? I have tried uninstalling Madcam and reinstalling however it defaults to my entry level key. I can't find a place to enter an upgrade key. Please help.

Regards,
Leonard

svenakela · #2 01-12-2012, 01:38 PM

You can do that with a madcamCommand in Rhino, but I'm not sure if that's documented (or is public). Contact your reseller and they know for sure how to do it.

eurolenny · #3 01-12-2012, 04:07 PM

I sent Joakim an e-mail about the same time I posted to the board and he replied with the necessary technique. My reseller redirected me to him anyway.

Great service. It was about 9:22 PM his time when he responded.

I've been very happy with my Madcam 3 axis, now I move into the 4th

Regrads,
Leonard

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
11m upgrading to 4 axis	cwtoyota	Fanuc	9	12-10-2009 01:14 AM
First entry	Abdul Shakoor	Europe Club House	0	08-19-2009 01:42 AM
helical entry min max rad?	manuelc149	Mastercam	2	12-18-2008 09:09 AM
Interactive Entry??	vladdy	G-Code Programing	1	08-22-2008 11:28 PM
Upgrading to a 4 axis lathe pc based control?	Delw	General Electronics Discussion	2	12-12-2007 05:40 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)