Madcam issue (coordinate zero)

[Woodworker24]

Hi everyone
I just bought Rhino and madcam, I can't figure out the 0,0,0 with madcam.
I have been using Bobcad and Aspire and setting up for the router on 0 is easy, madcam is something I can't figure out
Thanks for any info
Gary

[svenakela]

Hi Gary,

0,0,0 is the same as Origo in the coordinate system you see in Rhino. Super easy, if you move your model to 50,50,0 your machine will also start there.

Check this out: MADCAMCNC: Moving around in space

Regards,
Sven

[Woodworker24]

Hi Sven
I was assuming that but wasn't sure, I didn't see a path from the 0 so I wasn't sure
thanks for that
Gary