Setting some defaults

[OCNC]

Is it possible to set a default tool that sticks between sessions? Right now I'm getting a default entry of 'untitled'. Also I would like to change the default setting for the angle limit in the Planar finishing dialogue from 45.00 to 0.00. Is this possible and I guess the general question is can defaults be changed and how is it done?

Thanks.

Chris

[Dan B]

Hi Chris,

If you have defined your default tool library in the options, then the tools should be there for different sessions. I know they are for me.

As for changing the defaults within the specific cutter path dialogues, I don't believe that is possible at this point in time. However, watch for that in the future. MadCAM 5 is going to offer some new ways of doing things that should prove quite beneficial. I don't want to say too much, and I have yet to see an initial WIP, so I can't say specifically that your request will be there right away. However, discussions with Joakim on the subject of madCAM 5 have me pretty excited about the future of madCAM.

Dan

[OCNC]

Thanks Dan. It would be nice to have that ability in a future release. It would be nice too if items became scriptable.

Chris