Why is this happening? - CNCzone.com-The Largest Machinist Community on the net!

OCNC · #1 06-03-2011, 05:49 AM

I have a number of places in a roughing pass where the cutter stops and then slowly spirals down a small amount and then continues with the regular cutting pattern. Can someone explain why this is happening? Is it an anomaly of the code or does it have a purpose? If it's an anomaly can it be eliminated?

Thanks.

Chris

OCNC · #2 06-03-2011, 06:26 AM

Looking at this a little bit more it seems to have to do with setting an amount to leave in the roughing dialogue.

Chris

Dan B · #3 06-06-2011, 03:43 PM

Hi Chris,

Is there still an issue here, or did you answer your own question?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Mori w/ nothing happening	thesaurian	Mori lathes	2	03-02-2011 01:24 PM
Why is this happening?	absolutepoker01	WoodWorking	10	02-20-2010 09:38 PM
Weird Things Happening At My Relay @.@	sunmix	General Electronics Discussion	14	11-11-2006 09:59 PM
No fillet happening	R C	BobCad-Cam	0	07-17-2006 03:43 AM
ESTOP keeps happening	klick0	LinuxCNC (formerly EMC2)	2	12-17-2005 11:06 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)