spherical or lollipop cutters - CNCzone.com-The Largest Machinist Community on the net!

williamsmotower · #1 03-27-2011, 12:27 PM

Can these cutter types be defined in Madcam?

svenakela · #2 03-28-2011, 02:45 AM

Ball end yes, smaller shaft than the radius itself - no. MadCam doesn't use "back cutting", so it's more or less not useful. You can still use a sphericals as ball ends though.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Lollipop mills and HSMWorks	Gabe Newell	HSMworks	2	09-14-2009 01:05 PM
LETTERING HARDWOOD CUTTERS? AND PLYWOOD CUTTERS	andycorleone	WoodWorking	2	12-12-2008 12:36 PM
Is this spherical design possible, & if so, how do I do it?	Odin	General Metalwork Discussion	4	08-12-2008 07:33 AM
Lollipop cutters - anyone?	Andy Fritz	General Metalwork Discussion	3	05-24-2006 09:15 AM
Spherical Bearings	Robyn	Mechanical Calculations/Engineering Design	2	03-15-2006 02:55 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)