mach3 problem!! When i live a cnc mill to work a relief it does't do it right but it goes diagonally, i mean it deform the picture so that it is not squared but rhombus like, and also if i tell him to make 30x20 it makes it 33x20 or something like this what am i doing wrong?
before reinstalling mach3 everything was just fine i did Axisi Calibration
Working on 3 axis mashine
Here is a pic. on example
Last edited by pajdoosijek; 02-01-2012 at 04:51 AM. Reason: didnt put likn on my picture
Greetings to our friends in Croatia. All of the Mach3 experts hang out in this section of the Zone, Mach Software (ArtSoft software) - CNCzone.com-The Largest Machinist Community on the net! . I'm sure you'll get a faster reply if you post your question there. Good luck.