| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machinist Feedback Post your experience with members that have fulled your RFQ requests. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-01-2012, 02:49 AM
| |||
| |||
mach3 problem!! When i live a cnc mill to work a relief it does't do it right but it goes diagonally, i mean it deform the picture so that it is not squared but rhombus like, and also if i tell him to make 30x20 it makes it 33x20 or something like this what am i doing wrong? before reinstalling mach3 everything was just fine i did Axisi Calibration Working on 3 axis mashine Here is a pic. on example http://img855.imageshack.us/img855/5276/examplex.jpg Last edited by pajdoosijek; 02-01-2012 at 02:51 AM. Reason: didnt put likn on my picture  |
|
#2
02-02-2012, 04:40 PM
| |||
| |||
| Greetings to our friends in Croatia. All of the Mach3 experts hang out in this section of the Zone, Mach Software (ArtSoft software) - CNCzone.com-The Largest Machinist Community on the net! . I'm sure you'll get a faster reply if you post your question there. Good luck. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Mach3 problem with new cnc | jimmyaz | DIY-CNC Router Table Machines | 9 | 06-04-2011 06:38 AM |
| MACH3 -> LPT Problem! Help. | spotlite | Mach Mill | 3 | 08-06-2008 07:37 PM |
| mach3 problem | cicio | Australia, New Zealand Club house | 3 | 02-21-2008 02:54 AM |
| problem with Mach3 | jed102 | Mach Software (ArtSoft software) | 5 | 01-27-2008 04:38 PM |
| Problem with Mach3 | SCOTTY76SA | SheetCam | 3 | 05-27-2007 08:34 AM |
| | |
Linear Mode
