| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machinist Feedback Post your experience with members that have fulled your RFQ requests. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-21-2011, 07:36 PM
| |||
| |||
I'm looking to buy some 40mm insert face mills for roughing out some deep pockets in Aluminum on a new job we are starting. I want to go with a 90 deg insert. The deepest pocket is just under 8 inches (203.2mm). I'm looking at buying either a Sandvik 40mm or a Ingersoll 40 mm. Any feed back on the performance on these two brands will be helpfull Last edited by kalld; 09-21-2011 at 09:59 PM.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need help with pocketing | blondemale35 | Machines running Mach Software | 7 | 04-07-2011 07:11 PM |
| Need Help!- Small dia EM/Deep pocketing, speed and feed suggestions, minimize deflect | rough_cut | Canadian Club House | 3 | 01-06-2010 04:32 PM |
| Pocketing in V9 help | Joe Rodney | Mastercam | 5 | 02-26-2007 11:57 AM |
| Deep Pocketing Aluminum | John H | General Metalwork Discussion | 5 | 11-28-2006 08:15 PM |
| Pocketing | dneisler | BobCad-Cam | 4 | 12-18-2005 10:57 PM |
| | |
Linear Mode
