- Fuji CNC alarm 453 SPC soft disconnect alarm
-
Registered
Fuji CNC alarm 453 SPC soft disconnect alarm
Can anyone tell me if this is caused because the drive does not see the + - opposites from the pulse encoder as it should, checked connection at motor and was quite oily, cleaned and hooked back up but get same alarm after powering back up, so am I looking at the possibility that I have a bad cable or a bad pulse encoder. Just all of a sudden came up and have not been able to clear.
hvining
Similar Threads:
-
- Fuji CNC alarm 453 SPC soft disconnect alarm
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules