Looking for help in machining sintered material with a limited rpm of 6000 spindle sp

[rabcoman]

I'm having difficulty with cratering. Thinking about getting a cutter with tungsten and negative rake. Anyone have experience with this type of material?

Similar Threads:

• Just IN- LD-6000 Acrylic High Light Machining Center
• VM17 Spindle speed limited
• Mazak Nexus 6000 Horizontal Machining Center
• gibs from oilite bronze sintered bearing material instead of brass/bronze
• Novakon 6000 RPM spindle: Run at 9000 ??