| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-26-2009, 06:10 PM
| |||
| |||
Dear All, I have some problems at motor tuning and setup method. try motor tuning on mach3 of each axis. You can see G's , Step Pulse ( 1-5 us) and Dir Pulse ( 0-5) on the blank below. I try fill the numbers on these blanks but I don't see what is different as running my machine. Normally, G's should be=? , Step Pulse should be = ? ,Dir Pulse should be = ? G's , Step Pulse ( 1-5 us) and Dir Pulse ( 0-5). what does it mean? Pls advise. Sadheer  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MOTOR TUNING | corneliusbrown | Mach Software (ArtSoft software) | 3 | 06-10-2009 10:26 PM |
| New Machine Build- Mach3 , Config, Motor Tuning problem ( FILM OF MOTOR) | MDF_Markazi | Mach Software (ArtSoft software) | 7 | 04-30-2009 02:15 AM |
| Need Help!- Help with motor tuning | harrisam | DynaCNC | 8 | 05-09-2008 08:17 AM |
| Motor Tuning | dwacker | DIY-CNC Router Table Machines | 8 | 04-30-2007 09:50 PM |
| Motor Tuning | PEU | Mach Software (ArtSoft software) | 3 | 09-26-2005 11:48 PM |
| | |
Motor tuning and set up 
Linear Mode
