Dear All,
I have some problems at motor tuning and setup method.
try motor tuning on mach3 of each axis.
You can see G's , Step Pulse ( 1-5 us) and Dir Pulse ( 0-5) on the blank below.
I try fill the numbers on these blanks but I don't see what is different as running my machine.
Normally, G's should be=? , Step Pulse should be = ? ,Dir Pulse should be = ?
G's , Step Pulse ( 1-5 us) and Dir Pulse ( 0-5). what does it mean?
Pls advise.

Sadheer