conversion of anilam drives with mach 3 software

[ptpz]

This is all a little new to me, but I'll try to get up to speed. I have a mill that I
bought but the controller & display are junk. Does anyone have any info
as to what it would take to hook the anilam drives to the mach3 software
and hardware? Any help appreciated!!

Thanks

PTPZ

[ktb100]

Hi, Check and see if the drives can handle step (pulse) and direction. If so, no problem. You have numerous options. Here is a picture of Industry Controls motion board. It has step and direction and differential. The add on board available in about a month will operate +/- 10V. Encoder feed back is already built in and it has closed position loop built in. It uses a USB and not a parallel port. By using a 6" or shorter cable and keeping the USB board next to the PC, noise is controlled. The USB board then converts the signal through RS485 cables to the motion control board.

This board has been tested to transmit 200 feet while putting 18V AC on the ground of the machine without failure. It also has (18) Inputs and (8) 24Vdc relay outputs. There is a 50 pin header for an Opto 22. This can add more I/O at will.

I hope this helps

Cheers,

Kirk

[jalessi]

Kirk,

Do you have a website link for Industry Controls motion board?

Thank You

Jeff...

[ktb100]

the web site is www.industrycontrols.com It is under construction. pm me and I can send you a manual

Thanks,
Kirk

[ptpz]

I appreciate all the help from everyone. you will have to bear with me until I get up to speed on the posting etc. I have dealt with alot of steppers but this is my first undertaking of a servo conversion. Again thanks for the help!!!

PTPZ

[ktb100]

Here is the prerelease manual. It gives you a good idea of what it is.

Thanks,

Kirk

[ktb100]

Had to break the manual in to 3 pcs so it would fit

[ptpz]

Had to break the manual in to 3 pcs so it would fit

Thanks to both of you for the information [QUOTE=PTPZ

[ktb100]

We are expecting to be able to communicate +/- 10V in 2 months or less
with encoder feed back

[ptpz]

Had to break the manual in to 3 pcs so it would fit

ptpz]If possible could you get me the pricing and availability for these boards. If I could get a source it would really be great!!
Thanks,
PTPZ

[ktb100]

Sure, email info@majesticmachinery.com The Industry control web site is done yet.

Thanks,
Kirk

[Larry Patterson]

I am looking for a Anilam 3300 Mk control system for parts. Any help would be appreciated. Please call Larry at 801 216 4576. Thank you