I Have Lift Off ! - CNCzone.com-The Largest Machinist Community on the net!

SPEEDRE · #1 07-10-2008, 08:40 AM

After a few tweaks and a pulley change in config. it runs, and, it runs gooooood. I did the most bone headed thing and did not copy the license doc, into the Mach folder, so those of you who suspected a demo version,were right of course. I also got some config stats from K2CNC's web site and made a few changes and viola. got speed! I made a test over the piece I already had started and it completed the part. It's really shaby so I will not post a photo but later I'll have better ones to show. I sincerely thank all who guided me in my efforts you were right on brothers.

neilw20 · #2 07-10-2008, 09:28 AM

Experience is a good teacher. Cross the i's and dot the t's. Measure twice. Cut once.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Where to lift up IH ?	Juka	Industrial Hobbies (Support forum)	6	07-18-2007 11:26 PM
Need to build a lift table	watrout	General Material Machining Solutions	11	07-08-2007 09:29 AM
HF or Lift Arc Start for TIG	kramerda	Welding, Brazing, Soldering, Sealing	2	03-03-2007 01:15 PM
Concern with gantry lift	CuttersCov	DIY-CNC Router Table Machines	11	02-18-2006 07:30 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)