| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-16-2008, 04:11 PM
| |||
| |||
Check out this Hurco mill retrofit running Mach3 and Larken Viper Drives. http://www.cnczone.com/forums/showth...105#post411105  Dan the owner makes the fiberglass consoles for the Mach setup.  NIce mill.  Here is the controller running at 160 volts with the Viper servo drives. Larry kenny www.Larkencnc.com  |
|
#2
02-16-2008, 04:27 PM
| |||
| |||
| Wow! Great retrofit. Last edited by Mike Stevenson; 02-16-2008 at 10:44 PM. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HURCO mill retrofit | Larken | Viper Servo drives | 5 | 10-06-2008 08:07 PM |
| Mini mill running waiting | elitemachining | Haas Mills | 8 | 01-09-2008 06:40 PM |
| running mill with a pc | slamans | Milltronics | 4 | 10-16-2007 01:00 PM |
| VM1 Graphite Hurco Mill | loginname99 | HURCO | 1 | 08-21-2007 09:08 AM |
| Mill trips in middle of running | cut2spec | Benchtop Machines | 1 | 02-27-2007 07:19 PM |
| | |
Linear Mode
