How do you know IPM - CNCzone.com-The Largest Machinist Community on the net!

tdnp · #1 02-03-2008, 01:39 PM

I read alot of postings on how fast people are cutting, How do they know. I have looked through Mach 3 and do not see an IPM setting. This is a home built(not by me) and I am curious.

Thanks

mlind · #2 02-04-2008, 03:06 AM

Kcam has a real time IPM meter where you can see how fast you are cutting.

ger21 · #3 02-08-2008, 09:43 PM

Originally Posted by tdnp

I read alot of postings on how fast people are cutting, How do they know. I have looked through Mach 3 and do not see an IPM setting.

Your looking for the feedrate. On the program run screen.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)