| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-30-2008, 04:13 PM
| |||
| |||
When I use the feed rate ovveride it increases the rapid and euqal amount. for example if increase a feed rate from 4 to 6 IPM then my rapid icreaes from 60 to 90 IPM. Must be some box I need to uncheck or something EH.  |
|
#2
01-30-2008, 05:37 PM
| ||||
| ||||
| Try "No FRO on queue" in the general config. But be aware that this may cause a delay in the FRO. The recommended method is to increase the feedrate in your g-code and use the FRO to slow it down. Some development work is currently being done to the FRO, expect some changes there in the near future.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Feed Rate and Spindle Rate for this cut? | DroopyPawn | General Metalwork Discussion | 20 | 11-21-2007 11:12 PM |
| O mate M slow rapid rate Phase II | diemaker | Fanuc | 0 | 10-18-2006 04:08 AM |
| O mate M slow rapid rate | diemaker | Fanuc | 6 | 10-09-2006 02:14 PM |
| Feed Rate? | bearwen | GRZ Software- MeshCAM | 3 | 04-26-2006 04:52 PM |
| C & Z Feed rate | rfstar | G-Code Programing | 7 | 06-22-2005 12:38 AM |
| | |
Linear Mode
