| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-16-2008, 06:14 PM
| |||
| |||
Hi, I have Mach 3 running a cnc router, I have used it successfully several times, but if it is left for a week or two, on startup I can't get the Z motor to run, it will make sounds like it is running and sometimes will jump when I jog it, in the past it has seemed to cure itself but not today, I played with motor settings in all combos, nothing seems to help. Any body run into this problem? Thanks Terry  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems with motor stalling due to motor/lead screw alignment | Bimmerkc1 | DIY-CNC Router Table Machines | 3 | 01-24-2010 06:12 PM |
| Stepper Motor Problems | droddis | DIY-CNC Router Table Machines | 4 | 12-27-2007 07:23 PM |
| Motor/Controller PROBLEMS | wdenny | Stepper Motors and Drives | 10 | 05-04-2007 06:58 PM |
| Motor problems | johnm99 | Stepper Motors and Drives | 1 | 03-03-2006 02:11 PM |
| Motor Problems | MikeAber | Industrial Hobbies (Support forum) | 7 | 12-13-2005 11:22 AM |
| | |
Z motor problems? 
Linear Mode
