| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-26-2007, 02:10 PM
| |||
| |||
Powered up system for first time. All 5 volt power from transformer and usb working fine. Hooked up drives as per instructions regarding setting com to 5 volts on a C1 board from CNC4PC. Tested drives with self test and they work. My home and limit signals work, as the leds go on and off when I activate these switches. I get no power (leds do not light ever) from my outputs. I am using Mach3 software and have verified my parallel port. I have the X,Y and Z enabled and on low active, but I get nothing when I try to tune the motors. When I power up the system I get a thump on each motor, like locking into place. Can anybody offer any help?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| end of bar signal | positiverake1 | Daewoo/Doosan | 4 | 08-24-2007 07:34 PM |
| Diag: Output Signal: Enable 1 help... | Flatline's Up! | Syil Products | 11 | 04-06-2007 02:11 AM |
| Getting analog signal from pc | roni21702 | Computers and Networking | 1 | 06-15-2006 01:34 PM |
| Using the err signal | FrankdB | Servo Drives | 1 | 03-30-2005 06:10 PM |
| code 86 dr signal off | CBNDude | Mazak, Mitsubishi, Mazatrol | 13 | 03-25-2005 01:08 PM |
| | |
Linear Mode
