LinkBack URL
About LinkBacks
Nope, either one way or the other, but not both.
| | |
Can I use normal DIR/STEP control on some axis when
I'm using MaxCL mode?
I need quadrature pulses to X&Y and DIR/STEP pulses for Z...
Nope, either one way or the other, but not both.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Have you seen any schematic to change dir/step pulses to quadrature?
Maybe TTL chips: counter, coder and some diodes?
Posting Permissions
| | |
