| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-14-2007, 02:06 PM
| ||||
| ||||
Haven't used my CNC machine for over 6 months. When starting machine up again it wouldn't home. The following was in the command line 'Requested home axis homeswitch is active. Please fix then....'. All switches are Closed and the pin settings are correct. Any ideas?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Limit switches and homing switches | AeroKam | Open Source CNC Machine Designs | 16 | 01-05-2008 07:56 AM |
| About homing and limit switches . | stragenmitsuko | Mach Software (ArtSoft software) | 3 | 08-06-2007 06:48 PM |
| preliminary design... just playing around with sketchup | blau_schuh | DIY-CNC Router Table Machines | 3 | 07-23-2007 11:30 PM |
| Stepper motors playing music! | DennisCNC | CNCzone Club House | 3 | 01-01-2007 11:04 AM |
| Limits, homing, and relay switches | Bloy2004 | General Electronics Discussion | 3 | 11-24-2003 05:17 PM |
| | |
Linear Mode
