Need help with CNC retrofit near Toronto - CNCzone.com-The Largest Machinist Community on the net!

L98FIERO · #1 05-20-2007, 05:25 PM

I need some help with my CNC mill project. I am retrofitting a control using the original SEM brushed DC servos from an Anilam Crusader M, BgMikro UHU boards, a Campbell Combo board and Mach 3 and I've gotten to a point where my ambition has far surpassed my knowledge. I have most of the functions working, some better than others, and need to get it running reliably and wanted to know if some one is close enough and willing to help.

LaVerne

You can email me at L98FIERO at rogers dot com

L98FIERO · #2 05-22-2007, 08:03 AM

I've had someone contact me and most of my problems have been solved, Thanks Trevor!

LaVerne

protman16 · #3 05-22-2007, 12:06 PM

Any time.

Be sure to post your progress so that others with the same machine can get some ideas.

Trevor

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Toronto machinist?	Eric Schlieper	Teachers Hang out	1	03-08-2007 08:28 PM
Toronto or GTA area	sfr	Mentors & Apprentice Locator	0	10-17-2006 01:37 PM
anyone near Toronto ON Canada	paul nicholson	Mini Lathe	15	09-24-2006 09:50 PM
RFQ Milling-Toronto	Steve@Reliance	Employment Opportunity	2	07-27-2006 05:04 PM
CNC builders in Toronto/Canada	boratrade	Mentors & Apprentice Locator	6	05-03-2006 06:43 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)