| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-08-2007, 12:13 PM
| |||
| |||
New to all this a looking for a little direction. I have a Rockcliff machine up and running. However I can't figure out how to tell Mach3 how much xy movement there should be in the machine. Right now it tries to move further than it physically can. This is 12" X 12" machine in the xy direction. Is the size of the work table outlined in red a function of Mach3 or did it come from the information from which I converted to G-code (HPGL plt file) ? Thanks Last edited by ringram2077; 05-08-2007 at 02:39 PM.  |
|
#3
05-09-2007, 06:33 AM
| |||
| |||
| Greg Thanks for the help. Just what I needed ! Richard  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New setup with Mach3 - Limits work, homing doesn't | journeyonline | Mach Software (ArtSoft software) | 10 | 03-21-2007 09:09 PM |
| Out of limits | monte55 | Machines running Mach Software | 7 | 11-04-2006 09:28 PM |
| BP Series 1 with Mach3- Z axis limits issues | bbuonomo | Bridgeport and Hardinge Mills | 6 | 10-13-2006 04:39 AM |
| we all need limits! | senor J. | General Electronics Discussion | 28 | 08-24-2006 12:06 AM |
| limits | jc286006 | TurboCNC | 2 | 09-08-2005 05:05 PM |
| | |
Linear Mode
