| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-22-2007, 03:52 AM
| |||
| |||
Is it possible with Mach 3 to place multiple copies of a job on the table. There is a G-code to make roughing with one tool and finishing with another, so I would like to know if I can make roughing on multiple places and after tool change make the finishing. Use some macro or offsets. G-code is just for 1 piece !  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multiple Positions Available -TN | StacyE | Employment Opportunity | 0 | 04-19-2007 12:02 PM |
| Can one run 2 copies of DeskCNC at once? | greasetattoo | Carken Products (Deskam, DeskCNC etc) | 2 | 03-05-2007 04:49 PM |
| Multiple Routers? | GalaticDan | DIY-CNC Router Table Machines | 12 | 07-24-2006 11:16 AM |
| Multiple Parts | nitemare | G-Code Programing | 2 | 12-21-2005 07:14 PM |
| multiple vise's | smitty | TurboCNC | 5 | 05-08-2003 04:29 PM |
| | |
Linear Mode
