| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-17-2006, 02:33 PM
| |||
| |||
I need help!! I have wired my Gecko drivers to my stepers as directed. I am using a 48 volt DC power supply and have wired it. I am sending 5VDC of of pin #1 to my geckos 5VDC pin. I turn my 48 volt power on I have holding power to my motors but after configuring Mach2 my motors will not turn. I have limit switches wired according to Mach2 directions but also with no luck. (closed circut to ground, when circut open to Mach2)     |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
