| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-14-2006, 06:35 AM
| |||
| |||
| Feed Rate Overide problem Hope someone can answer this.. I have my router (Mach2) set to cut at 8000mm per min, no problem. Feedrate set by the NC code. However, if I run a program at say 4000mm per minute and then increase the feedrate above 100% using the DRO's it then get jerky movements etc.... This only happens when increasing the Feedrate above 100% even though the actual feed rate is well below the maximum. Any ideas. cheers Frans    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
