I have a big problem with my computer, i will believe it is mach 3....
If I turn on the cnc machine and leave it on for about 45 minutes. Then it will start and run all 3 steppers one way with a low speed ..
To get the machine stable again, I must restart the MACH3.
If the CNC is in no contact with the computer, it will not happen.
Is there any way I can find out what is wrong?
It remains only to try a completely fresh installation of MACH3.
My second homebuilt cnc machine cnczone.com/forums/norwegian_club_house/123977-ombygget_cnc_-_gecko_540_a.html