| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-05-2011, 03:21 PM
| |||
| |||
I upgraded to the latest version today and now my y axis is not running normal it kind of sputters and does not move at the normal speed. All settings are the same as the old version and X A Z axis are working normally. When it installed it did the parallel driver, could that cause this or do you think this is a driver board issue? I checked and the stepper is fine, the board is a TB6560. Any ideas how to un install the parallel driver that was included with the software? The old version of Mach does not communicate with the driver board anymore... Time for a G540?   |
|
#2
11-05-2011, 08:14 PM
| ||||
| ||||
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Strange behavior with VFD | BanduraMaker | Gecko Drives | 3 | 11-15-2011 08:00 AM |
| NM-200 - strange behavior? | kvom | Novakon Systems | 1 | 07-28-2011 06:14 PM |
| NM-200 - strange behavior? | kvom | Novakon Systems | 3 | 05-24-2011 08:28 AM |
| New Machine Build- Strange Behavior. | riveracnc | Mach Software (ArtSoft software) | 2 | 11-28-2008 06:54 PM |
| Milltronics strange behavior | KBHone | Milltronics | 1 | 12-09-2007 05:00 PM |
| | |
Linear Mode
