Jog z axis - CNCzone.com-The Largest Machinist Community on the net!

alex718 · #1 01-26-2011, 11:21 AM

I use Mach 3 on my machine and can jog the x and y with the arrow keys on the keyboard. I have not figured out how to jog the z axis on the keyboard. Any suggestions ?

Thanks

ger21 · #2 01-26-2011, 05:20 PM

Page Up/Page Down.
You can also change them using Config>Hotkeys.

alex718 · #3 01-27-2011, 09:43 AM

Thank you, I should have thought of that. Its obvious now that you have told me.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Dual Y Axis Slave A Axis Homing Problems	guy2b1	Calibration & Measurement	4	03-03-2012 04:06 PM
the Difference of 2-Axis and 3-Axis of Vertical Mill Machine	begacon	Knee Vertical Mills	6	07-30-2009 06:31 AM
New Machine Build- post for 2 axis ez trak versus 3 axis ez vision	tooolman	G-Code Programing	0	11-28-2008 03:33 PM
Compare Catia and MCX2 for multi axis lathe/4 axis mill	bob1112	General CAM Discussion	0	10-10-2008 07:15 PM
New Design - Hybrid 3-Axis Router/4-axis Foam Hot Wire Cutter	the__extreme	CNC Wood Router Project Log	3	02-26-2007 02:58 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)