| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-29-2010, 07:41 PM
| ||||
| ||||
HI, I am a newbie to this so be gentle with me. Hopefully this is an easy question. I am running Mach3 with a Gecko G540 driver. My gcode has a M3 command to start my router but i need to configure my hardware and software, so i am looking for the steps needed to make this happen. I plan on using a relay to turn on the router. How do i configure Mach3 to turn on an output thru my Gecko G540? Thanks farmertom  |
|
#2
12-29-2010, 09:38 PM
| ||||
| ||||
| Ports and pins, spindle tab. Uncheck the box in the upper left corner, and choose an output number for M3. Then go to the output tab and set up that output # with the correct pin number from the G540. I don't have a G540, so I can't help with the relay.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to turn a 1965 Mustang Convertible into a CNC Router | jallenmorris | CNCzone Club House | 5 | 07-31-2010 08:11 AM |
| Newbie- How Mach3 can Turn On/Off my Router during operation? | guy2b1 | General Electronics Discussion | 8 | 10-26-2009 05:26 AM |
| Router Won't Turn On At Beginning of Program | notselrach | Machine Problems, Solutions , Wireless DNC, serial port | 1 | 02-06-2009 03:08 PM |
| Need Help!- G-Code to turn on and off router, non-spindle | Sam A | G-Code Programing | 6 | 10-24-2008 08:02 PM |
| circuit to turn on router head | treemagnet | DIY-CNC Router Table Machines | 9 | 03-24-2004 09:15 PM |
| | |
How to turn on my router? 
Linear Mode
