LinkBack URL
About LinkBacks
Sorry if I posted that in the wrong area, but since it was related to a Gecko Drive change and XML file... oh nevermind. Just glad its where you want it now.
Radius to end of Arc Differs From Radius to Startline
Ok... Why? I mean I used this G-code file to cut an actual work piece under my previous profile. However under the Gecko XML I get this error.
What setting would be different that the code would be good in one, but not the other?
I reloaded my old profile and loaded the same g-code file just to make sure and it did not stop at this as an error.
Bob La Londe
http://www.YumaBassMan.com
Sorry if I posted that in the wrong area, but since it was related to a Gecko Drive change and XML file... oh nevermind. Just glad its where you want it now.
Bob La Londe
http://www.YumaBassMan.com
It's a Mach3 issue, not a Gecko issue, so I moved it to the Mach3 forum.
As you saw in the Mach forum, it's probably due to the IJ mode. Change it in General Config.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Posting Permissions
