| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machines running Mach Software Discuss your set-up and experiences running your machine using Mach software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
06-21-2010, 05:21 PM
| ||||
| ||||
| Try increasing the debounce in General Config, top right corner.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
#5
07-06-2010, 06:01 PM
| ||||
| ||||
| IN the Spindle Tab of Ports and Pins, right above the mist and Flood, assign the output to Clockwise.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| help Homeing fadal vmx15 no experiance | One eye doc | Machinist Feedback | 3 | 12-13-2009 01:43 PM |
| Homeing | frankg521 | Mach Mill | 7 | 07-31-2007 07:21 PM |
| | |
Linear Mode
