Featurecam

[Bell 430]

Grretings fellow chip makers!

I have a shopmaster eldorado bridge mill, running mach3 (lisc version)
I have access to featurecam 2010. I've done my drawings on solidworks 2009, then imported to featurecam, then tried to output NC code to mach 3, BUT things didn't go well.
Can someone tell me what post I need inorder for this setup to work?

Thanks

[Bell 430]

thanks for the info, I had searched, but I didn't see any of these posts

[edsimmons]

I use the Fanuc OM post (Modified a little) to run my 3 Axis Shizouka ST-N.

GL!
Ed